Did the fault light come on and go back off? So, anila, control software appears to run properly on the PC. This message occurs because you can only have 50 elements, which consists of line, points, or circles, in the Geometry Calculator section. This is going to erase memory and clear your problem. Program the sample programs and change the numbers to suit what you want to machine. Did you have the key plugged into the printer port before the power was on? Install the software answering the question anilak they show on the screen. The ‘motion control board’ looks like a regular ISA-bus board. You have just backed up your configuration file. Loosen the GIB a couple of turns and try the same test again. I’m not familiar with the M or sure what. I run a Sharp knee mill with a Aniliam M control. Anilam is the company that makes the control. Does anyone know how to repair the system?. Hello, Out Anilam m 2 axis system is giving us no video and the computer will not boot. Will the drive motors from the anilam work with a mach 3 system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |